Heath-zenith Motion sensing Pendant Light 4350 User Manual download pdf (Page 3)

3

598-1219-05

INSTALL UNIVERSAL MOUNTING

BRACKET

Canopy Screw (x3)

(Tightened Finger

Tight)

Junction Box

Universal Mounting

Bracket

Mounting Bracket

Screw (x2)

ASSEMBLE CANOPY

1. Determine the number of mounting rods needed

to mount the pendant light. Any combination of

the 3 mounting rods may be used. Note: For

best performance, mount the xture so that the

sensor is between 8 and 10 feet (2.4 m) above

the ground.

2. Determine which mounting rod will connect to

canopy.

3. Locate the 1" (25.4 mm) threaded rod.

4. Connect the end of the threaded rod with the

thread sealant to the mounting rod that will

connect to the canopy. Hand tighten securely.

Note: Excess sealant may have to be trimmed

away for best appearance.

5. Place the small, thick, decorative washer onto

the threaded rod.

6. Place the decorative at washer onto the

threaded rod.

7. Place canopy onto threaded rod.

8. Place the other large washer onto the threaded

rod.

9. Place the S-Hanger Terminal onto the threaded

rod with tab facing away from canopy.

10. Place star washer onto threaded rod.

11. Screw nut onto threaded rod and tighten se-

curely with wrench.

Nut

Star Washer

S-Hanger Terminal

Flat Washer

Canopy

Decorative Flat Washer

Small, Thick,

Decorative Washer

1" (25.4 mm) Threaded Rod

Mounting Rod

End with Thread

Sealant

WARNING: Turn power off at circuit

breaker or fuse.

1. Remove universal mounting bracket from canopy

by removing the 3 knurled canopy nuts.

2. Tighten the three canopy screws nger tight.

3. Attach universal mounting bracket to junction

box securely with the two screws provided.

1 2 3 4 5 6 7 8 ... 23 24

Comments to this Manuals

No comments