Heath-zenith 5718 User Manual download pdf (Page 3)

598-1308-02

Wire the Light Control

White to White

Black to Black

Junction box ground wire to

green ground screw on ﬁxture.

Gasket

Mounting Strap

Mounting

Bolt

Rubber

Plug

Mount the Light Control

❒ Align the light control cover plate and cover plate

gasket. Secure with the mounting bolt.

❒ Align the three slots in the decorative shell with the

lamp holder pins. Push the shell in and then twist

clockwise to lock. Repeat for other shell.

Lock Nut

To avoid water damage and electrical shock,

keep lamp holders 30° below horizontal.

❒ Adjust the lamp holders by loosening the lock nuts

but do not rotate the lamp holders more than 180°

from the factory setting. When screwing in the

ﬂoodlamps, do not overtighten.

Keep lamps at least

1" (25 mm) from the

sensor. Do not allow

the lamps to block

the lens.

Lens

❒ Push the rubber plug ﬁrmly into place.

❒ If a wet location junction box was not used, caulk

the wall plate mounting surface with silicone

weather sealant.

Shell Slot

❒ Remove the existing light ﬁxture.

❒ Install the mounting strap as shown using two screws

that ﬁt your junction box.

❒ The plastic hanger can be used to hold the ﬁxture

while wiring. The small end of the plastic hanger

can be threaded through the hole in the center of

the cover plate. The small end then goes into one

of the slots on the mounting strap.

❒ Route the light control’s wires through the large

gasket holes.

❒ Twist the junction box wires and ﬁxture wires together

as shown. Secure with wire connectors.

WARNING: Turn power off at circuit breaker

or fuse.

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Heath-zenith 5718 User Manual Page 3

Comments to this Manuals

Related products and manuals for Safety Heath-zenith 5718