Heath Zenith Hardwired Mechanical Chime 598-1112-05 User Manual download pdf (Page 2)

-2-

598-1112-05

CHIME REPLACEMENT INSTALLATION

Note: Electrical work must be in accordance with national and local

electrical codes. If in doubt, consult a qualiﬁed electrician.

1. Verify transformer power rating. Power must be supplied from

a 16 Volt AC, 10 Watt or a 16 Volt AC, 15 Watt transformer

(Heath

/Zenith models 122C, 121AC, or 125C).

2. Remove cover from existing chime.

3. Label all wires before disconnecting. Using masking tape, mark

each wire according to existing chime terminal markings.

• “F” – Front Push Button Wire

• “T” – Transformer Wire

• “R” – Rear Push Button Wire*

4. Disconnect all wires from existing chime.

5. Remove existing chime base from wall.

6. Determine proper chime base orientation. The chime cover

style may determine orientation.

7. Determine cover mounting type. For hang pin and hole type

covers, hang pin should be installed before mounting base to

wall. Install hang pin by snapping into mounting hole or sliding

onto chime base, depending on type of hang pin (see Figures 1

and 3).

Illustrations may vary from actual chime unit.

Figure 1 - Mechanical Chime Identiﬁcation

(Model 35 Base Shown)

REAR

TRAN

Hang Pin, Snap-On

Type (Used for Hang

Pin and Hole Covers)

Base Orientation

Marking

Wire Entrance Hole

Mounting Slot (x4)

Tone Bars

Transformer and

Push Button Wire

Connections

Continued

Plungers

Hang Pin Mounting

Slot (Horizontal)

Hang Pin Mounting

Slot (Vertical)

Hang Pin, Slide-On Type

(Used for Hang Pin and

Hole Covers)

1 2 3 4 5 6 7 ... 23 24

Comments to this Manuals

No comments

Heath Zenith Hardwired Mechanical Chime 598-1112-05 User Manual Page 2

Comments to this Manuals

Related products and manuals for Unknown Heath Zenith Hardwired Mechanical Chime 598-1112-05