Heath Zenith UT-5666-AL User Manual

Browse online or download User Manual for Unknown Heath Zenith UT-5666-AL. Heath Zenith UT-5666-AL User's Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
100 Watt H.P.S.
Dusk-to-Dawn Security Light
© 2008 HeathCo LLC 598-1288-04
Lens/Reflector
Assembly
Mounting
Arm
Lag Screw (4)
Flat Washer (10)
Mounting
Bracket
Photocontrol
Ground
Screw
10. Connect thexture wires to the service wires using the wire nuts
provided (black to black and white to white). Push the connec-
tions as far as possible into the straight arm.
11.
This xture must be grounded. Connect the service ground under the
head of the green ground screw and secure to the mounting strap.
12. Install the lens/reflector assembly with two screws and washers
provided.
13. Screw in the 100 watt H.P. Sodium type S54 bulb provided.
14. Loosen the screw in the center of the photocontrol socket two
turns. Twist the socket so that the arrow points north. Note: There
is a stop to prevent the socket from turning all the way around. If
you have trouble turning the socket, try turning it the other direc-
tion. Retighten the screw in the center of the socket.
15. Align the photocontrol (it will only plug-in one way). Plug it in
and twist clockwise until it stops.
To test operation during the daytime, cover the photocontrol with
a small box or rag. Turn the power on. Light should turn on and
reach full brightness within ten minutes. Remove the box or rag to
expose the photocontrol to daylight. Light should turn off within
two minutes. With the photocontrol exposed, the light will operate
automatically – on at dusk and off at dawn.
Mounting Strap
Silicone
Caulk
Questions or problems? Before returning to your retailer, call our
technical service department at 1-800-858-8501 (English speaking
only), 7:30 am to 4:30 pm, CST, Monday – Friday.
INSTALLATION INSTRUCTIONS
WITH TWO PIECE ARM
Estimated Installation Time: 60 minutes
Items needed for installation (not included):
Phillips and flathead screwdrivers
13 mm, 10 mm, and 8 mm sockets
3/16" Drill bit Drill
Pliers Wire strippers/cutters
Safety glasses Silicone caulk
Ladder Small box or rag
READ ALL INSTRUCTIONS CAREFULLY BEFORE
BEGINNING INSTALLATION.
NOTE: All wiring must be run in accordance with the National
Electrical Code (Canadian Electrical Code in Canada)
through conduit or another acceptable means. Contact a
qualified electrician if there is any question as to the suit-
ability of the system.
Item Model
247591 UT-5666-AL
WARNING: Turn power off at the circuit breaker or
fuse.
1. Select a location on a flat wall with structurally sound wood and
from 10 to 25 feet (3 to 7.6 m) from the ground. The wood should
be at least one inch thick to safely secure the fixture.
2. Slide the curved section of the mounting arm into the mounting
bracket. Tighten the bolts on the mounting bracket evenly.
3. Using the mounting arm and bracket as a guide mark four mount-
ing holes. We suggest drilling 3/16" (4.8 mm) pilot holes for the
lag screws.
4. Mount the arm and bracket using four lag screws and washers
provided.
5. Place a ring of silicone caulk around mounting arm (see illustra-
tion). Slide the straight section of the mounting arm on to the
curved section aligning the predrilled holes.
6. Secure the two sections with two bolts, nuts and four washers
provided. Place silicone caulk on top of the bolts and washers
to prevent water from entering.
7. Thread your outdoor cable or flexible conduit through the mount-
ing arm.
8. Loosely connect the mounting strap to the fixture using two bolts
provided.
9. Slide the fixture on to the mounting arm until the fixture comes
to a stop. Secure the fixture to the mounting arm by tightening
the two mounting strap bolts.
Package Contents and Fixture Assembly
Bulb
Lamp in Fixture Contains Mercury. Dispose According
to Local, State, or Federal Laws.
Page view 0
1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - Dusk-to-Dawn Security Light

100 Watt H.P.S.Dusk-to-Dawn Security Light© 2008 HeathCo LLC 598-1288-04Lens/Reflector AssemblyMounting ArmLag Screw (4)Flat Washer (10)MountingBracke

Page 2 - INSTALLATION INSTRUCTIONS

10598-1288-041. Choisissez un endroit sur un mur plat, à ossature de bois solide, à 3 à 8 m (10 à 25 pieds) du sol. Le bois doit avoir au moins 25 mm

Page 3 - Ignitor

11598-1288-04Douille d’ampoule Ballast Igniteur Rouge Rouge Rouge Noir Noir Bleu Bleu Blanc Blanc Blanc Noir Blanc Noir Douille de la cellule photo-é

Page 4 - THREE YEAR LIMITED WARRANTY

12598-1288-04GARANTIE LIMITÉE DE 3 ANSIl s’agit d’une « Garantie limitée » qui vous confère des droits juridiques spécifiques. Vous pouvez également jo

Page 5 - CON BRAZO DE DOS PIEZAS

2598-1288-04Cover PlateMounting PlateLag Screw (3)Flat Washer (9)PhotocontrolGround Screw1. Select a location on a flat wall with structurally sound w

Page 6 - SIN BRAZO DE DOS PIEZAS

3598-1288-04Lamp Socket Photocell Socket Ballast Ignitor Red Red Red Black Black Blue Blue White White White Black White Black 120V ACInputBallast As

Page 7 - Encendedor

4598-1288-04THREE YEAR LIMITED WARRANTYThis is a “Limited Warranty” which gives you specific legal rights. You may also have other rights which vary fr

Page 8 - GARANTÍA LIMITADA A 3 AÑOS

5598-1288-04 Lámpara de Seguridad de Sodio de Alta Presión (H.P.S.) del Crepúsculo al Amanecer de 100 VatiosConjunto de la pantalla traslúcida/reflecto

Page 9 - Luminaire de sécurité

6598-1288-041. Seleccione una ubicación en una pared plana con una madera es-tructuralmente firme y entre 3 a 7.6 m (10 a 25 pies) del suelo. La madera

Page 10 - SANS BRAS

7598-1288-04Zócalo de la lámpara (boquilla) Estabilizador Encendedor Rojo Rojo Rojo Negro Negro Azul Azul Blanco Blanco Blanco Negro Blanco Negro Zóc

Page 11 - Igniteur

8598-1288-04GARANTÍA LIMITADA A 3 AÑOSEsta es una “Garantía Limitada” que le da a Ud. derechos legales específicos. Usted puede también tener otros der

Page 12 - GARANTIE LIMITÉE DE 3 ANS

9598-1288-04Luminaire de sécuritécrépuscule-aurore au sodiumhaute pression (SHP de 100 W)Ensemble lentille/réflecteurBras de montageTire-fond (4)Rondel

Comments to this Manuals

No comments