Heath Zenith Lighting Controls 598-1306-02 User Manual download pdf (Page 6)

6 598-1306-02

Installing Wall Switch Receiver

Wall Switch Screw

Junction

Box

Wall

Switch

ON/OFF Button

DIM Button

Ground Wire (Bare or Green)

Wall

Power Disconnect Switch

Antenna

Installation

1. Select light switch to be replaced by wall switch receiver.

WARNING: Turn off the power to the light switch circuit

before you proceed. Do this at your circuit breaker or fuse box.

3. Remove the existing wall plate and switch. Disconnect the two

power wires and the ground wire.

Note: If there are more than two power wires attached to the switch,

consult an electrician about installation. In addition, some local build-

ing codes may require installation by a qualied electrician.

Important Information Regarding 3-Way Switch Installations:

In order to use this product where two switches are being used

to control the light, the 3-Way Wall Switch transmitter will also

have to be installed. Refer to the 3-Way Wall Switch Installa-

tion section for details.

Wall Plate

Screw

Wall Plate

Important: When ganging these units, they must be derated as

follows:

Features and Ratings:

• Up to 500 Watt maximum incandescent load depend-

ing upon switch purchased. See rating label on switch

for exact load rating.

• Not for use with Compact Fluorescent bulbs.

WARNING: FOR USE ONLY with 120 volt incandescent

or halogen bulbs.

CAUTION: To reduce the risk of overheating and pos-

sible damage to other equipment, do not install to control a

receptacle, a motor-operated appliance, a uorescent lighting

xture, or a transformer-supplied appliance.

WALL SWITCH RECEIVER

4. If necessary, strip away 1/2" of insulation from end of wires.

5. Connect one of the black power wires from receiver to one of the

power wires you removed from the old switch. Use one of the

supplied wire connectors to secure the wires (see illustration).

6. Connect the second black power wire from receiver to the other

power wire you removed from the old switch. Use one of the

supplied wire connectors to secure the wires (see illustration).

7. Connect the green ground wire from receiver to the ground

wire removed from old switch. Use one of the supplied wire

connectors to secure the wires (see illustration).

8. Check wire connections to make sure they are secure and that

no bare wires are exposed.

9. Route antenna between the bottom of the junction box and the

wall. Feed antenna into wall cavity while placing wall switch

into junction box.

10. Position the wall switch receiver in the junction box with the DIM

button located to the right. Use the two wall switch screws (long)

supplied to mount the receiver to the wall box (see illustration).

Push excess wiring into wall box while you do this. You may

need to bend the wires to t inside the box. Mount wall plate on

wall switch receiver with screws (short) provided.

11. Turn on the power to the light switch circuit. Do this at your

circuit breaker or fuse box.

Gang 1 2 3

300 W 300 W 300 W 300 W

500 W 500 W 475 W 450 W

RECEIVER INFORMATION

All receivers have the following features and ratings:

• Rated for 120VAC/60Hz supply voltage.

• Uses existing wiring.

• Fits standard single gang junction box (wall switch only).

• Not for use with Compact Fluorescent bulbs.

• When rst turned on wait 15 seconds.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Heath Zenith Lighting Controls 598-1306-02 User Manual Page 6

Comments to this Manuals

Related products and manuals for Motion detectors Heath Zenith Lighting Controls 598-1306-02